Ademco 4190SN Multiplex 2-Zone 2-Wire Expander.

Complete Description Below:

Ademco 4190SN Two-Zone Remote Point Module

The ADEMCO 4190SN addressable V-Plex™ module is a two-zone expander which allows use of the available expansion zones provided by ADEMCO controls that support V-Plex devices.

• Serial mode programmable
• Left Zone - EOLR supervised, open or closed circuit sensors
• Right Zone - unsupervised, closed circuit sensors
• UL listed for fire and burglary installations

This Zone Expander Runs On 2-Wire Twist. Serial Number Addressing.

Pooling Loop

Used on the Vista-40- 50P-128-250

FEATURES

The 4190SN consists of two detection loops, known as the left (primary) and right (secondary) loops. The left loop can be used for:

• Closed-circuit devices with or without EOLR supervision
• Open-circuit devices, with EOLR supervision
• Fast-response (10 millisecond) devices

Follow the chart below for cutting the correct jumpers and choosing the correct resistor when using the left loop. The right loop can be used for:

• Closed-circuit devices only
• Has no EOLR supervision
• 400 millisecond response time  

The jumpers do not affect the operation of the right loop. The right loop cannot be used alone.

Supervision:

The tamper/supervision response of the 4190SN is determined by the zone response type assigned to the left loop zone. While the system is armed, tamper/supervisory faults will report as alarms if the left loop zone is assigned a burglary response type and will report as troubles if the left loop zone is assigned a non-burglary response type (i.e., fire, panic, aux). While the system is disarmed, tamper/supervisory will always report as troubles.

SPECIFICATIONS

Physical:

• Width: 2-1/8" (53mm)
• Height: 3-1/4" (81mm)
• Depth: 1" (25mm)

Electrical:

• Voltage input: 8-11VDC
• Current drain: 2mA
• Max. loop wire run: 100’
• Max wire gauge: 18 awg

AGENCY LISTINGS

• UL Listed for Commercial

Programming Notes

Program the unit like any other zone, according to the alarm control’s installation instructions.

Enter the following information when prompted for in programming:

• "INPUT TYPE" = "6" (SL—Serial Number Device)
  Left Zone = Loop I
  Right Zone = Loop 2

UL Notes

• The right loop may not be used for Commercial Fire or UL Commercial Burglary installations.
• For Commercial Fire usage: Use N.O. contacts on the left loop. Supervise (style B) this loop using Model #610-11 Fire Listed 10K ohm EOLR (purchased separately as part of the 4100 EOLR resistor kit).
• For UL Commercial Burglary Usage: Use N.O. or N.C. contacts on the left loop. Supervise using the 10k ohm EOLR supplied.