|
Altronix 12/24 Volt 7 Amp 16 Output Power Supply
Overview:
The Altronix ALTV1224C AC/DC Dual Output Power Supply is designed
to provide both 12VDC and 24VAC outputs where a combination of both AC and DC outputs are
required.
It will provide eight (8) 3.5 amps 12VDC outputs and eight (8)
3.5 amps 24 VAC outputs. Simoulstainly
Specifications:
• 115 VAC 50/60 HZ, 1.52 amps.
• 7 amps total continuous output current.
• 16 individually fused outputs.
• 3.5 amps continuous supply current at 12VDC (Fig. 1).
• Eight (8) output @ 12VDC.
• 3.5 amps continuous supply current at 24VAC output.
• Eight (8) output @ 24VAC.
• Output fuses are rated at 3.5 amps / 250VAC.
• Main fuses are rated at 5 amps / 250VAC (Fig. 1).
• Surge protection.
• AC /DC power LED indicator.
• Power ON/OFF switch.
• Spare fuses included.
• Unit maintains camera synchronization.
• Ease of installation saves time and eliminates costly labor.
Enclosure dimensions: 15.5"H x 12"W x 4.5"D
Optional available with
220VAC input order model # ALTV1224C/220.
Installation Instructions:
1. Mount ALTV1224C enclosure in desired location.
2. Slide switch SW1 (Fig. 1) to OFF position.
3. Connect the AC (115 VAC 50/60 Hz) to the two black and white flying
leads of the transformers (Fig 1).
4. Measure output voltage before connecting devices.
5. Connect devices to output terminals using the following procedure (Fig. 1).
Connect each DC device to terminal pairs on DC output board 1 thru 8, marked P (+) and N
(-) carefully observing correct polarity.
Connect each AC device to terminal pairs on AC output board 1 thru 8,
marked P (+) and N (-).
6. When batteries are being used the DC output voltage must be adjusted by
turning the trim pot VR1 (Fig 1) clockwise to increase the output voltage to 13.7 VDC. Connect
battery to terminals marked - BAT + (Fig.
1) on the unit (battery leads included).
CAUTION: Determine the maximum operating voltage of the equipment being
powered before adjusting the output voltage. When the battery charging voltage is
increased the DC output voltage will also increase.
7. Slide switch SW1 (Fig. 1) to ON position.
8. Green LED on the PD8’s will illuminate when power is present.
9. Upon completion of wiring, secure enclosure door with screws
(supplied).
WARNING: To reduce the risk
of fire or electric shock, do not expose the unit to rain or moisture. This installation
should be made
by qualified service personnel and should conform to all local codes and
in accordance with the National Electrical Code.
|
