|
X-10 3 - 4 Way Decorator Rocker Slave Switch
Needed In Conjunction With The XP3DIW To Allow 3 And 4 Way X-10 Circuits To
Operate Properly
Diagram shown, the XPSS (Slave Switch) connected to an
XPS3, 20Amp Wall Switch
The XPSS Momentary Slave Switch is designed to operate in conjuction with
the
XPD3, XPDI3, and the XPS3 Wall Switches. The XPSS Slave Switch is not a
load
bearing switch, it simply transmits signal over the dedicated traveller
wires to the
Master Switch for auxillary control. The LED on the Slave Switch is non
functional
and there are no House and Unit codes to set.
3-Way Application
• When creating a three-way application, simply connect the 120VAC
(referred to as
Line or Live) to the XPSS. Line can come from either wall box in the
application and
connect to the Traveller, carrying Line to the other location.
• Connect the Traveller that carries the Control from the Master to
the Switch position
on the XPSS Slave.
4-Way Applications
• When creating a four-way application, simply parallel another XPSS
across the
same two travellers from the first Slave location. Connect wires from
Switch to
Switch and Live to Live, using the feed thru screw terminals.
Note: Typically the "center" Switch will have 4 wires, two from
the master and two
from the last slave. Place the two wires carrying Line in the socket
marked Live on
the XPSS. Then place the other two wires carrying Control to the Switch
position on
the XPSS.
|
